[wcm_restrict]

The Evolved Training private Facebook group is LIVE
Click Here To Join

———————

This is Week 1 of the THIRD (and final) MESOCYCLE in the Power Building Program.

Look to progress the REPEATING movements slightly, and exceed the performance from “week 1” of the prior mesocycle

It’s important to begin each mesocycle (4-5 week training period) with slightly less perceived effort and leave room to build week to week. The ultimate goal is to progress perceived difficulty week to week so that the FINAL week of the mesocycle is the most challenging.

You can learn more about this process of increasing PERCEIVED EFFORT in this Instagram post

Please read the PowerBuilding BLOG to learn about this training cycle

RIR = “Reps in Reserve”
(If the programming calls for “3 reps with 2 RIR,” this means you *could* complete 5, but stop at 3)

Remember that it’s still progress if you REPEAT the prior weeks’ performance, but do it better!

It’s also worth noting that the percentages associated with the backoff sets will increase gradually over time; but even if the percentage stayed the same, progress would still occur as dictated by improvement on the top set.

———————

Day 1 – Lower Posterior and Upper Body Pull
Part A and B repeat week to week. Track metrics

A. Deadlift
Reps performed with STOP briefly on ground, providing time to reset and ensure optimal movement pattern

Build to one top set of 3 Reps (with a solid 2 RIR)
Then complete 3 sets of 2 reps @ 91% of top set

———————

B. Weighted Pull-ups (@21X0) (Scaling below)
21X0 = 1-sec pause at bottom (full hang position)
***Choose neutral, pronated, supinated, or rings, and stay consistent week to week

Build to one top set of 3 Reps (with a solid 2 RIR)
Then complete 3 sets of 2 reps @ 91% of top set
(Remember to take 91% of the total: BW + added weight)

SCALING:
Weighted “negatives” (lowers)
4 sets of 3 Reps
Use heaviest weight to start, and lower weight set to set as needed to ensure QUALITY
***Prioritize the portion of the movement where you STRUGGLE the most. Really make sure you take 3-4 seconds to lower through that top part of the rep (and obviously keep control throughout the entire lowering process) (total time should be around 5-6 seconds per rep)

If you cannot yet perform Pull-up Lowers in 5-6 seconds per rep, then use:
Machine-Assisted Pull-ups
Rack Pull-ups (foot assisted)

———————

C. Unilateral Hinge and Curl x 3 Rounds:
First round lighter, warm-up weight, then two challenging rounds

Rear-Foot Elevated DB RDL x 12-18 Reps
Rest 1-2 min after both legs
Concentration Curls x 12-18 Reps
Rest 1-2 min after both arms

———————

D. Alternate Movements x 2 sets each:

Seated Leg Curl OR Lying Leg Curls x 12-18 Reps
Rest 1-2 min
Jansen Rows x 12-18 Reps
Rest 1-2 min

———————

Day 2 – Upper Body Push + Core
Part A and B repeat week to week. Track metrics

A. Pause Bench Press OR Pause Machine Chest Press (of choice)
(choose; stay consistent week to week)
Reps at 21X0 tempo, meaning 1-sec pause at bottom, and minimal or no pause at top of rep

Build to one top set of 3 Reps (with a solid 2 RIR)
Then complete 3 sets of 2 reps @ 91% of top set

———————

B. Incline DB Bench Press
Build to one TOP set of 4-6 Reps (2 RIR)
Then 1 x 6-8 at reduced weight

———————

C. Pre-Exhaust Superset x 3 sets each:

“Bowing” DB lateral Raises x 10-15 Reps
Strict Barbell Upright Rows OR Smith Machine Upright Rows x 8-12 Reps
Rest 2-3 min

———————

D. Pre-Exhaust Superset x 3 sets each:

Hinged Cable Pushdown x 15-20 Reps
Incline DB Squeeze Press x 8-12 Reps
Rest 2-3 min

———————

E. Superset Abs/Core Movements x 3 sets each:

V-ups x 12-20 Reps (scale as Lying Leg Raises)
Heavy Russian Twists x 12-20 Reps (6-10/side)
Rest 2-3 min

———————

Day 3 – REST DAY

———————

Day 4 – Full Lower Body (Quad focus) + Core
Part A and B repeat week to week. Track metrics

A. Back Squat
Build to one top set of 3 Reps (with a solid 2 RIR)
Then complete 3 sets of 2 reps @ 91% of top set

OR choose a machine version (with slightly higher target rep range)
Whatever choice you make, stay consistent week to week

Hack Squat OR Other Squat Machine of choice
Build to one top set of 6 Reps (with solid 2 RIR)
Then complete 2 sets of 6-8 Reps @ 86% of top set

———————

B. Choose Movement (stay consistent week to week)
5 sets of 6-10 Reps
Once you can achieve all 5 sets in the 8-10 range, add weight on just the first 2 sets. Over the next couple weeks, match that loading on the other sets. Work towards all 5 sets achieving the 8-10 rep range with the new loading, then repeat process

Weighted Hip Extensions
OR
45-Degree Hip Extension (add load as feasible)
OR
45-Degree Hip Extension + GHR finish (add load as feasible)
OR
Glute-Ham Raise (add load as feasible)
OR
Reverse Hyper (if available)

———————

C. Giant Set x 2 Rounds:
This is gonna hurt quite a bit. Stay focused on quality form, and push through the burn to that rest period awaiting you between rounds!

Hack Squat (if not used in Part A) OR Leg Press x 12-18 Reps @ 20X0 tempo (no pause at top)
Jumping Lunges x 12-20 Reps (6-10/leg)
Air Squats x 12-20 Reps @ 20X0 tempo (this means controlled descent and no pause at top!)
Rest 3+ min between rounds

———————

D. Alternate Movements each minute x 10 Minutes
Goal to work for 20-25 seconds and rest for 35-40 seconds each minute

Min 1: Hanging Oblique Knee Raise x 12-20 Reps (6-10/side)
Min 2: Decline Sit-ups  x 8-12 Reps (add weight as feasible)

———————

E. Single-Leg Calf Raise (Riser + DB)
1 x 8-10 (challenging, heavy)
1 x 12-15 (moderate)
1 x 15-20 (BW only)

———————

Day 5 – Full Upper Body
Parts A, B and C repeat week to week. Track metrics

A. Strict Overhead Press OR Machine Overhead Press (of choice)
Reps at 21X0 tempo, meaning 1-sec pause at bottom, and minimal or no pause at top of rep

Build to one top set of 3 Reps (with a solid 2 RIR)
Then complete 3 sets of 2 reps @ 91% of top set

***If performing “machine Overhead Press” stay consistent week to week
Build to one top set of 6 Reps (with solid 2 RIR)
Then complete 2 sets of 6-8 Reps @ 86% of top set

———————

B. Strict Pendlay Row OR T-Bar Machine OR Hammer Strength Row
(choose one and stay consistent week to week)

4 sets of 6-10 Reps
Once you can achieve all 4 sets in the 8-10 range, add weight on just the first 1-2 sets. Over the next couple weeks, match that loading on the other sets. Work towards all 4 sets achieving the 8-10 rep range with the new loading, then repeat process

———————

C. Weighted Dips (or scaled with Assisted Dip Machine)
Reps at 21X0 tempo, meaning 1-sec pause at bottom, and minimal or no pause at top of rep

Build to one top set of 4-7 Reps (with a solid 2 RIR)
Then complete 3 sets of 10-20 Reps (BW only, or assisted as needed)
***If you somehow can make 3×20 with BW, add some light loading and continue protocol

The goal will be to increase the Reps OR LOADING on the first set, and potentially the total number of reps achieved with BW each week (sometimes avoiding HARDEST set in the beginning will leave you fresh and have more to offer the last set)

———————

D. Alternate Movements x 5 sets each:
Reps 20-15-10-15-20 (increasing then decreasing weights for each movement)
*Try to use the SAME WEIGHTS in building, as you do in descending (I.e. 20-rep sets are both with the same weight; meaning you should stay a bit shy of fatigue on the “building” portion)

DB Fly/Press Hybrid
Rest 1-2 min
Standing Curl (EZ or BB)
Rest 1-2 min

———————

Day 6 – OPTIONAL Conditioning

A. 10 Rounds:
Note mandatory rest after each round. Goal is for approx 1:1 work to rest ratio

Run 150m
5 Burpee Box Jumps
10 DB Thrusters
Rest 90 seconds

———————

B. Walk at recovery pace as desired

——————————————–

[/wcm_restrict]